It can be used when modifying a drive that has been recognized as HDD to SSD. Open this feature from “Menu” → “Recognized drive settings”.

If operation, the right column is marked with a circle(“○”). If “×”, a drive is not currently connected and has only been connected once in the past. Also here, check the left end so that can process all at once.

Returns the cumulative scan time that accompanies a full scan to 0 seconds.

Please use when required to use a HDD and absolutely need to switch it temporarily. Especially in the case of an external drive, there are many cases where ATA command does not work well and is mistakenly recognized. If restart this software, will return to the original state, and only temporary.