目次 [INDEX]

Millisecond inspection is developed from data recovery. Therefore, it will run inspection from the data recovery feature.

Millisecond inspection cannot be processed at the same time. Please run one by one.

Click No.1 “Setting bad sector danger prediction (millisecond inspection)”.

No.2: A graph that changes from moment to flows here, a drives that have no stability issues will stick near the top or return, immediately when lowered.
No.3: The processing amount is displayed. (Mainly for debugging)
No.4: The direction of the graph that changes from moment to moment is quantified and displayed at the top, slight change, and bottom.
No.5: This is the analysis result. However, only the “stability index” at the bottom can be used for inspection. This index denotes “drive strength” and is considered as [UP]. If there is no problem, and [DOWN], if there is a slight problem, the healthy drive is 60-100, which is [UP], if there are many weak parts, will be 50 or less, and the possibility of being judged as [DOWN] increases.

The operation is strange immediately after the start, and considered as [DOWN].
Bad sector danger prediction (red-line) works well to prevent from sticking to the bottom and getting stuck, this is a pre-avoidance.

If the drive head is broken, will not recover anymore, and will continue to go down. Let’s give up and switch to a new one. However, this drive has bad sectors, so it is still good. If this is a drive that hides bad sectors to the end, only bad sector inspection will go unrecognizable without noticing the bad.